For anyone who has made a few pieces of resin art, you'll have seen the intricate patterns that collect on the table below your canvas as the resin drips over the edge. You just couldn't replicate such gorgeous marbling if you tried! It's probably crossed your mind that you could turn it into jewellery and this post shows you one way that you can. You'll need a die cut machine like a Sizzix Big Shot and steel rule die to cut the resin - plus my special tip which you can see in the video further down the page. Here's what you need: Resin Art overflow (or skin) no thicker than 1.5mm (1/16") Drill with 1mm drill bit Sizzix Big Shot Sizzix die - I used Flowers #4 (657011) which has been retired. Try this one instead: 660659 or hunt around for a second hand one on your favourite pre-loved goods site. 2 4mm Swarovski bicone crystals (I used Montana) 2 silver ball head pins Fine cable chain 6 x 4mm silver jump rings 2 oval jump rings 2 earring wire......
